Hard Disk Drives - EFI E-85 Installation And Service Manual

5 Connect one of the SATA power cables to the power connector on the dual data/power cable that connects to the DVD
drive.
6 Connect three of the other SATA power cables to the SATA power connectors on the three hard disk drives.
7 Connect the power cables to the motherboard (see
• 8-pin power cables to connectors PW2 and PW3
You may connect either 8-pin cable to either power connector on the motherboard.
24-pin power cable to connector PW1
•
8 Replace the tie wraps that you removed earlier.
9 Reassemble the E-85 and verify its functionality (see

Hard disk drives

The factory-installed hard disk drives (HDD) are formatted and loaded with system software, network drivers, and printer
fonts. The hard disk drives are also used to store spooled print jobs.
If you replace a hard disk drive with a new one, you must reinstall system software and user software on the system.
(Replacement hard disk drives are not shipped with preinstalled software.) The E-85 remains enabled for features such as
the Fiery Graphic Arts Package, once the software is reinstalled.
This section includes separate procedures for replacing a hard disk drive installed inside the E-85 and replacing a hard disk
drive installed inside the enclosure of the HDD Security Option.
Proper handling
Important: Improper handling can damage the hard disk drive. Handle the hard disk drive with extreme care.
• Use standard ESD practices when grounding yourself and the E-85.
Keep magnets and magnetic-sensitive objects away from the hard disk drives.
•
Do not remove the screws on top of the hard disk drives. Loosening these screws voids the warranty.
•
• Never drop, jar, bump, or put pressure on the hard disk drives.
• Handle the hard disk drives by the sides and avoid touching the printed circuit boards.
Allow the hard disk drives to reach room temperature before installation.
•
Hard disk drive problems may be caused by the following:
• Loose or faulty connection
• Faulty hard disk drive
Installation and Service Guide: Color Controller E-85
Figure 25 on page 47 and
page 83).
Replacing parts
Figure 32 on page 58):
76