Figure 39: Removing/Replacing The Back Fan - EFI E-85 Installation And Service Manual

3 Remove the four plastic rivets that secure the fan to the chassis, and then remove the fan.
To remove a rivet, use a flathead screwdriver to pry loose the rivet head while squeezing and pushing the locking end of
the rivet with your fingers or a screwdriver.

Figure 39: Removing/replacing the back fan

1 Fan assembly
2 Airflow direction
To replace the back fan
1 Position the fan against the chassis.
When correctly positioned, the metal grille on the fan should be facing away from the connector panel, and the fan
cable should be able to reach its connector on the motherboard.
2 Align the four holes on the fan with the four holes in the chassis, and replace the four rivets that secure the fan to the
chassis (see Figure 39
Hold the fan firmly against the chassis, and push each rivet all the way until it snaps into locked position. Make sure
that the fan is tightly secured to the chassis.
Note: If you damaged the original rivets while removing the old fan, use the rivets provided in the bag labeled "BACK
FAN." This bag of rivets accompanies the spare fan kit.
3 Screw (1/4)
on page 73).
Installation and Service Guide: Color Controller E-85
1
2
Replacing parts
3
73