Figure 41: E-85 hard disk drives (HDDs)
1
HDD1
2
HDD2
3
HDD3
4
HDD sled
5
Bracket screw
To remove a hard disk drive
1 If you have not done so already, ask the site administrator to print the Job Log and save any custom simulation and
output profiles. If possible, print the following:
Server Configuration page lists any installed options and records the customer's current Setup configuration (for
•
more information, see
•
Font List lists the fonts currently on the hard disk drives. Along with the fonts provided, the customer may have
installed additional fonts (for more information, see
2 Shut down the E-85, remove all cables from the back, and then open the system (see
To access the hard disk drives, you must remove the left panel.
3 Remove the power cables from all three hard disk drives.
4 Remove the data cables from all three hard disk drives.
5 Remove the screw that secures the HDD bracket to the HDD slot in the chassis.
page
27).
Installation and Service Guide: Color Controller E-85
1
4
2
3
5
page
27).
Replacing parts
page
48).
78