Ping Watch Dog - TP-Link TL-WR940N User Manual

Chapter 5
3. Click
4. The
the following figure, the connectivity of the internet is fine.
Note:
Only one user can use this tool at one time. Options "Number of Pings", "Ping Size" and "Ping Timeout" are used for the
Ping function. Option "Tracert Hops" is used for the Tracert function.
5. 7. 2.
The Ping Watch Dog is dedicated for continuous monitoring of the particular connection
to remote host using the Ping tool. It makes the router continuously ping a user defined
IP address (it can be the internet gateway for example). If it is unable to ping under the
user defined constraints, the router will automatically reboot.
1. Visit http://tplinkwifi.net, and log in with the username and password you set for the
router.
2. Go to
• Enable
• IP Address
sending ping packets.
• Interval
• Delay
Downloaded from ManualsNet.com
Start to check the connectivity of the internet.
Diagnostic Results page displays the diagnosis result. If the result is similar to

Ping Watch Dog

System Tools > Ping Watch
- Turn on/off Ping Watch Dog.
- The IP address of the target host where the Ping Watch Dog Utility is
- Time interval between two ping packets which are sent out continuously.
- Time delay before first ping packet is sent out when the router is restarted.
search engine
Configure the Router in Access Point Mode
Dog. Configure the settings and click Save.
88