TP-Link TL-WR940N User Manual page 67

Chapter 4
•
•
•
•
Tunnel 6to4
•
•
•
•
Downloaded from ManualsNet.com
• Primary IPv6 DNS
notation provided by your ISP.
• Secondary IPv6 DNS
hexadecimal notation provided by your ISP.
Use the following IPv6 DNS Servers
addresses, select Use the following IPv6 DNS Servers
IPv6 DNS and Secondary IPv6 DNS
Connection Mode - The way to connect the ISP.
• Alway On - Connect automatically.
• Connect Manual - Connect by the user manually.
Connect - Click Connect
Disconnect - Click Disconnect
Address/Subnet Mask/Default Gateway
default gateway assigned, in dotted-decimal notation.
Tunnel Address - The 6to4 tunnel address created by the device to access the
IPv6 network.
MTU Size - The normal MTU (Maximum Transmission Unit) value for most
Ethernet networks is 1480 Bytes. For some ISPs, you may need to modify the
MTU. But this is rarely required, and should not be done unless you are sure it is
necessary for your ISP connection.
Use the following IPv6 DNS Servers -
addresses, select Use the following IPv6 DNS Servers
IPv6 DNS and Secondary IPv6 DNS
servers will be assigned from ISP dynamically.
• Primary IPv6 DNS
notation provided by your ISP.
search engine
Configure the Router in Standard Wireless Router
- Enter the DNS IPv6 address in colon-hexadecimal
- Enter another DNS IPv6 address in colon-
- If your ISP gives you one or two DNS IPv6
in the corresponding fields.
to connect immediately.
to disconnect immediately.
- The IPv4 address/ subnet mask/
If your ISP gives you one or two DNS IPv6
into the correct fields. Otherwise, the DNS
- Enter the DNS IPv6 address in colon-hexadecimal
and enter the Primary
and enter the Primary
62