Leg Support Height And Length Adjustments - Meyra Netti DYNAMIC AdaptPro User Manual

Netti Dynamic Dual leg support is offered in 2
different lengths.
Netti Dynamic Dual short leg support lengths suits
persons with lower leg length from circa 350 mm up to
approximately 500 mm (measured when knees are 90°
flexed, from underneath the thigh to under the heel -
inclusive normal shoes).
Netti Dynamic Dual normal leg support lengths suits
persons with longer than 500 mm lower legs.
5.10.1 LEG SUPPORT HEIGHT AND
LENGTH ADJUSTMENTS
Leg support adjustment takes place in 2 directions.
First adjustment is the foot board height and the
second adjusting the seat plate depth. The aim is have
the leg support knee joint and the user knee joint
aligned in the same axis.
Measure the user's lower leg length F - 90 degrees
bent knee - measure from underside thigh to the
underside heel of normal used shoe.
The centre joint of the leg support is hidden under the
knee-joint upholstery. The illustration with removed
upholstery shows the leg support knee-joint centre
which is to be at the same axis as the knee-joint of the
user. Adjust the foot board height according to the
lower leg length measured.
Netti Dynamic DUAL:
Foot-board height adjustment
• Loosen the M6 screws holding the leg support
length-profile on the outside with 5 mm Allen key.
• Adjust the foot-board to a height from top of front
edge seat cushion to the foot-board equal to the
lower leg length - F dimension.
1 pc 5 mm Allen key
Make sure there is enough free space under
the foot-board for the wheelchair to pass
minor obstacles. Slightly tilting the seating
unit may help. If not sufficient, the chair height
must be adjusted as described in this user
manual chapter 5.4
42
My-Netti.com
F
Model: Netti Dynamic AdaptPro
Language: English Version: 2021-11