Table of Contents
Advertisement
5.3.7 DRUM BRAKE ADJUSTMENT
The wheelchair is fitted with hand operated drum
brakes.
If the brake does not brake properly:
Adjust the wire on one or both sides, adjust the foot
screw 2-4 rounds out. Then re-check the brakes.
If the wire is too loose:
Adjust the foot screw all the way in. Tighten the wire
by loosening the wire clamp before pulling the wire
further through it. Tighten the wire clamp, and adjust
the foot screw out again
1 pc 10 mm open-end spanner.
To ensure the correct functions of the wire,
these must never be taut.
5.3.8 OPERATING THE BRAKES
Operating and applying the attendant brake
The wheelchair is fitted with hand-operated hub
brake handles for the drum brakes, to allow regu-
lation of speed on hills and whilst travelling along.
These are located on the push bow.
• To apply the brakes, pull the brake levers (1)
evenly and smoothly towards handle and bring
the wheel chair to a stop.
• The parking brake is at the same time the user
brake.
Operating and applying the user brake /
parking brake
The wheelchair is fitted with hand operated user
parking brake, one on each sides. The user brake
activates the same drum brake as the attendant
brake.
• To activate the parking brake:
push the handles on both sides, forward.
• To release the brakes: lift the handles up.
The user brakes cannot be used as running
brakes.
Do not leave the user in the wheelchair
without activating the parking brake.
24
My-Netti.com
Model: Netti Dynamic AdaptPro
Language: English Version: 2021-11
Advertisement
Table of Contents
