Meyra Netti DYNAMIC AdaptPro User Manual page 50

GRANDIS FOOT PLATE DEPTH ADJUSTMENT:
• Unscrew the 2 screws completely as shown below, using
an 5 mm Allen key.
• Pull out the foot plate and loosen the next 2 screw which
has become visible.
• Slide the footplate forwards or backwards to desired
depth before re-fixing all screws.
LOCKING AND RELEASING THE FOOT PLATES
• The foot plates come with a lock connecting the 2 foot
plates which makes the plates stronger.
• To lock the foot plates let the right foot plate fall cover
the bolt standing out from the left one, it clicks into lock.
• To release the foot plate push the plastic knob under the
right foot plate and lift the right foot plate up.
While making the adjustment, there must be no
load on the foot plates.
For outdoor use, there should be a clearance of
40-50 mm between the foot plate and the ground.
When adjusting leg support angle, be aware of
squeeze hazard between moving parts.
REMOVING THE GRANDIS LEG SUPPORT:
• Release the foot plate by pushing the red plastic knob
under the right foot plate and lift the right foot plate up.
• Pull the red circular grip on top of the leg support and lift
the support upwards while turning it slightly outwards.
GRANDIS CALF SUPPORT ADJUSTMENTS
The calf support is height and depth adjustable and are to
be adjusted in a height and depth that prevents the feet
from sliding down from the foot plate.
For chair width 43-60cm where the high version of calf
support is used, there are possibility for conflict with heel
or seat plate when the leg support is adjusted for short leg
length.
For height adjustment, loosen the screw on the calf
support bracket and slide it into required position before
fixing the screw.
Make sure to adjust the calf support that they do not
conflict with seat plate or foot plates.
To adjust in depth of the calf pad, loosen the screw
holding the calf support and slide it to required position
before fixing the screw again.
5 mm Allen key
50
My-Netti.com
info@solidworks.com
info@solidworks.com
info@solidworks.com
info@solidworks.com
Model: Netti Dynamic AdaptPro
Language: English Version: 2021-11