Meyra Netti DYNAMIC AdaptPro User Manual page 48

LOCKING AND RELEASING THE FOOT PLATES
• To lock the foot plates, let the right foot plate fall
over the bolt standing out from the left one, it clicks
into lock.
• To release the foot plate pull the plastic lock
between the foot plates and lift the right foot plate
up.
While making the adjustment, there must be
no load on the foot plates.
For outdoor use, there should be a clearance
of 40-50 mm between the foot plate and the
ground.
Never stand on the foot plates due to the risk
of tipping forward.
CALF SUPPORT ADJUSTMENTS
The calf supports are height and depth adjustable. The
calf supports must be adjusted in a height and depth
that prevents the feet from sliding down from the foot
plate.
HEIGHT ADJUSTMENT:
Loosen the nut A on the calf support bracket and slide
it into required position before fixing the screw.
10 mm open end spanner
DEPTH ADJUSTMENT:
Loosen the screw B between the calf support and
bracket and reposition it to required position before
fixing the screw.
13 mm Allen key
Never stand on the foot plates!
Never lift the wheelchair by the leg supports.
REMOVING THE LEG SUPPORT:
• If there is a foot plate lock, release the foot plate by
pulling the red plastic lock between the foot plates.
• Lift the right foot plate up.
• Lift the leg support in the knee joint slightly up.
• Swing it out wards
• Lift it up.
48
My-Netti.com
3
1
Model: Netti Dynamic AdaptPro
Language: English Version: 2021-11
2