Meyra Netti DYNAMIC AdaptPro User Manual page 39

Available belts and harnesses:
• Pelvic stabilizer - (included in Netti Dynamic System)
• Upper body harnesses
• Ankle huggers
• Shoe shells
Pelvic stabilizer,
mounted to the seat plate, helps the user to keep
his/her position on the seat even under full spastic
extension.
HOW TO ADJUST THE PELVIC STABILIZER
The pelvic stabilizer is mounted on the belt fixing
brackets on the seating plate as shown on the
illustration.
• Slide the pelvic stabilizer to a position where it
crosses the upper thighs, Angle: 70- 90 degrees.
• Adjust the pelvic stabilizer / belt mounting point for
the belt to be tightened.
• Remember to shorten the stabilizer beneath the last
used hole to avoid any conflict with chair frame.
A pelvic stabilization belt must always be used
when using upper body harness.
The seat plate is prepared with mounting loops on its
rear end for fixing the 2 rear belts of the 4-point pelvic
stabilizer.
H-BELT RACK FOR UPPER BODY HARNESS
Upper body harness rail is mounted to the chair-back
profiles by separate brackets.
See separate Mounting Description for upper body
harnesses at: www.bodypoint.com
ANKLE HUGGERS AND SHOE SHELLS
helps to keep the feet on the foot board not letting
them slide of during an extension spasm.
The ankle huggers are mounted by threading them
through the slots in the foot board on the leg support
and fixing the belt on the underside of the foot
plate, threading shown in the illustration - follow the
numbers.
Model: Netti Dynamic AdaptPro
Language: English Version: 2021-11
info@solidworks.com
info@solidworks.com
39
My-Netti.com