Chair Back Assembling And Positioning; Adjusting The Velcro Back; Placing Back Support Cushion - Meyra Netti DYNAMIC AdaptPro User Manual

5.5 CHAIR BACK ASSEMBLING AND
POSITIONING
• To mount the recline gas spring, lift the back rest
by its push bow with one hand, and lead
the gas spring locking head into the
covered steel bracket which is sitting
on the lower cross beam.
• Secure the back rest by pushing the
locking bolt in from the side, through
the bracket and gas spring locking head.
To check that the back rest is locked, grip the
push bow and press the back rest forward.
If the backrest falls forward - repeat the
locking procedure or contact your dealer.

5.5.1 ADJUSTING THE VELCRO BACK

• Loosen the straps, and place the back rest
cushion so that user gets room for the bottom
and the integrated lumbar support in correct
position.
• Tighten the straps so that they follow the
curvature of the spine and gives a little extra
support at the top of the sacrum.
5.5.2 PLACING BACK SUPPORT
CUSHION
The back support cushion are fixed and adjusted on
the wheelchair using the back Velcro.
It is imperative to correctly set-up the seat
and the back cushions in order to ensure
good seating comfort.
The cushion covers are washable and
thereby reusable. Follow the instruction on
the back of the cushion for correct
maintenance and washing of the cushion.
30
My-Netti.com
Model: Netti Dynamic AdaptPro
Language: English Version: 2021-11