Table of Contents
Advertisement
5.3.5 CORRECT FRAME ANGLE
To ensure good driving characteristics you need
to check and adjust - with drive wheels and
front castors mounted - that the lower frame is
horizontal and the front castor bearing house is
vertical.
See dotted red lines.
ADJUSTMENT OF THE ANGLE OF
BEARING HOUSE:
• Unfix the screw in the front of the bearing
house cover and remove the cover.
• Loosen the 2 screws clamping the bearing
house and move the bearing house up or
down until it has 90 degree angle to the level
ground when the wheelchair is standing on all
4 wheels.
• If necessary to get the bearing house
easier moveable, you can slightly screw the
middle set screw inward. This will open the
bearing house clamping and ease the height
adjustment.
• Screw the set screw outward before..
• Tightening the 2 bearing house clamping
screws.
• Replace the cover.
• Repeat on the other side.
Check angle of castor bearing house.
1 pc 5 mm Allen key
5.3.6 MAIN WHEEL QUICK RELEASE
The quick Release axle links wheel and frame. The
nut sitting under the head of the 'quick release
axle can be adjusted to fit the axle tightly when
inserted into the frame.
Adjust the nut backwards towards the axle head if
the axle does not click in .
Adjust the nut forwards if the axle sits loose when
inserted through wheel and brake.
Model: Netti Dynamic AdaptPro
Language: English Version: 2021-11
23
My-Netti.com
Advertisement
Table of Contents
