Table of Contents
Advertisement
5.7 NETTI DYNAMIC HEAD SUPPORT
ASSEMBLING AND POSITIONING
5.7.1 NETTI DYNAMIC C HEAD SUPPORT
The Netti Dynamic AdaptPro is as a standard
equipped with a Netti dynamic head support. The
head support follows the backward movement of the
head when the head is pressed against it.
A small cylinder dampens the movement and brings
the head back to normal position after extension.
5.7.2 NETTI DYNAMIC HEAD SUPPORT
ADJUSTMENTS
Mounting and removing
• To mount the dynamic head support, lift up the
handle on top of the back gas cylinder.
• Insert the 2 head supports rods into the top.
• Fix at any desired height by pushing the handle
down.
HEIGHT ADJUSTMENT OF THE HEAD SUPPORT.
The middle of the head support cushion shall be
positioned to meet the head slightly lower than the
most rearward part of the head.
• Open the handle holding the 2 vertical pole of the
head support.
• Pull the head support up or down to desired
height and close the handle by pushing down.
• A plastic rectangular stopper is mounted to the
vertical bars.
• When the correct height is defined, push the
stopper down till it meets the top of the gas
cylinder house.
• .
DEPTH ADJUSTMENT:
• Unlock the two red levers,, one on each side of the
head support horizontal tube.
• Move the head support forwards or backwards to
desired position.
• Fix the two levers firmly.
HANDLE ADJUSTMENT:
The main handle can be adjusted to keep its
tightness holding the head support stable.
• Remove the gas cylinder cover to get access
to the 2 screws shown on the picture.
• Tighten or loosen according to the need.
36
My-Netti.com
Model: Netti Dynamic AdaptPro
Language: English Version: 2021-11
Advertisement
Table of Contents
