Table of Contents
Advertisement
CALF BELT
Do not drive without the calf belt. – Danger
of accidents.
The removable calf belt (17 on page 40) pre-
vents the feet from sliding off the back of the
footboard.
Removing the calf belt
To remove the calf belt, open the velcro fasten-
er.
Attaching the calf belt
For attachment, guide the calf belt around the
frame tubes [18 on page 40] and close the
velcro fastener.
Length adjustment of the calf belt
For length adjustment the calf belt is adjusted
in corresponding length with help of the velcro
fastener.
FOOTBOARD
Do not drive with the footboard folded up-
ward. – Danger of accidents.
Folding the footboard up/down
The footboard is to be folded up for entering or
exiting the wheelchair [19 on page 40].
☞ Check the locking points!
1.
Remove both feet from the foot plate.
2. Remove the calf belt (1), if present.
☞ Therefore observe chapter Calf belt on
page 16.
☞ Before starting to drive the footboard has
to be folded down [18 on page 40] and
the calf belt attached.
16
BACK SUPPORT BELT
Fitting the back belt
The overlapping of the Velcro fastener has to
be at least 10 cm!
The tension of the back support is adjustable.
1.
Pull off the flap of the back support and
fold it to the front [20 on page 40].
2. Open the Velcro fastener of the belt that
you wish to adjust and close it again after
adjustment.
3.
Pull the back belt to the back again and
attach the velcro strap (21 on page 40).
Removing the back support uphol-
stery
For removal, first pull off the rear part of the
back support upholstery, then fold it over to
the front [22 on page 40] and pull it off of the
adjustable back strap (23 on page 40) [24 on
page 40].
Placing the back support upholstery
For applying, place the back support uphol-
stery centred around the upper back support
tube [21 on page 40] and attach with the
velcro fasteners to the adjustable back support
strap [25 on page 41].
☞ When the user leans against the back sup-
port upholstery (26 on page 41) again,
pay attention that:
☞ The pressure of the back must be spread
evenly throughout the back support up-
holstery.
☞ The head of the user must be held in bal-
ance through the adjustment of the span-
ning straps.
The extended back part of the adjustable
back support strap (23 on page 40) is fas-
tened to the seat with the velcro surface [24 on
page 40].
Advertisement
Table of Contents
