Paper Feed Trouble - Ricoh PRIPORT VT 2000 Series Service Manual

2.2 PAPER FEED TROUBLE

1. No paper is fed from the paper table.
Are the paper feed rollers turning normally?
No
Yes
Does the paper feed table raise when the Print Start key is
pressed?
Yes
Has the surface of the paper feed roller been damaged?
Has the timing belt slipped off the paper feed roller pulley?
No
Has the plunger of the paper feed solenoid been pulled out?
Yes
No
Is there enough clearance between the paper feed sector gear
stopper and the stopper pin?
Yes
Is the paper feed solenoid energized?
Is the paper feed sector gear turning normally?
Yes
No
Check the paper table drive motor,
paper height sensor, and AC drive board.
Yes
Replace the roller. (See page 5-50.)
Yes
Put belt back on.
No
Adjust the clearance. (See page 5-46.)
No
Check the paper feed solenoid
and the main control board.
No
Check the sector gear mechanism.
7-11
28 February '91