7.7 PAPER FEED ROLLER FEED-LENGTH ADJUSTMENT
[B]
Purpose: To ensure paper feed to the second paper feed roller.
1. Stack about 100 sheets of 65 g/m
2. Set the paper feed roller pressure adjusting lever in the upper position.
3. Remove both front and rear covers.
4. Access I/O check mode (See page 4-11).
Enter "0" in the memory display and "4" in the copy counter.
•
5. Press the Print Start key to raise the paper table to the correct position.
6. Turn on the paper feed solenoid [A] manually. Then, turn the rollers
counterclockwise by rotating the shaft [B] with a spanner (10 mm).
7. Measure the length of paper fed from the time the paper feed roller starts
rotating until it stops rotating. This feed-length should be 93 to 97 mm.
8. If the feed-length is incorrect, adjust the feed-length by loosening the
hexagon nut [C] mounted on the sector gear. Then, shift the bearing [D]
up or down.
9. After adjustment, repeat steps 5 and 6 again.
[C]
[D]
93 -- 97 mm
[A]
paper on the paper table.
2
5-45
28 February '91