Ricoh PRIPORT VT 2000 Series Service Manual page 223

28 February '91
2.8 ORIGINAL FEED ROLLERS / PULL-OUT ROLLERS
REPLACEMENT: VT2300/2500
[B]
1. Remove the original table (See page 5-2).
2. Replace the pull-out rollers [A] (1 snap ring, 1 pin).
3. Remove the E-rings at the both end of the original feed roller shaft [B].
4. Remove the ADF drive gear [C] and bushing [D].
5. Remove the original feed roller assembly [E].
6. Remove the stopper [F] (Allen screw).
7. Replace the original feed rollers [G].
NOTE: A one-way clutch is installed in the feed roller. Confirm that the
roller can rotate in the arrow direction as shown in the above
illustration.
[D]
[C]
[G]
[F]
5-10
[E]
[A]