28 February '91
3.1.1 Preparation for Adjustment
1. Remove the original table cover.
2. Connect the terminals of the oscilloscope to the following test pins on the
A/D Conversion PCB.
VT2100/VT2130/VT2150
Terminal
Channel 1
Channel 2
GND
VT2100/VT2130/VT2150
3. Turn on the power switch while holding down the Print Start key, Stop key
and Clear key on the operation panel. --- LT version only
Turn on the power switch while holding down the Print Start key, Stop
key, Clear key and the Full Master Detecting switch. --- A4 version only
4. Set "15" in the copy counter and set "0" in the memory/class display to
turn on only the fluorescent lamp.
Test Pin
TP 600
TP 603
TP 602
VT2300/VT2500
VT2300/VT2500
Terminal
Channel 1
Channel 2
(Black Level
Standard Voltage)
GND
* The trigger terminal is TP 603
5-12
Test Pin
TP 601
TP 600
TP 604
.