Ricoh PRIPORT VT 2000 Series Service Manual page 212

NOTES
1. The image density is lower than with a type 900 master; however, the ink set-off on the
back side of the following pages is reduced.
2. The image density is lower than with a type 905 master; however, the ink set-off is
reduced.
3. The image density is higher than with a type 905 master and the ink set-off is increased.
4. The image density is lower than with a type 900 master; however, the ink set-off is
reduced and the image density in solid areas is more even.
5. When the 500 cc ink cartridge is installed, the ink holder spacer [A] (P/N C5264633) must
be installed as shown.
6. The image density is slightly higher.
7. The drum cannot be used used unless the black seal [B] (P/N C2074550) is affixed to the
screen edge as shown. The drum lock function cannot be used.
8. The drum cannot be used unless the black seal [B] (P/N C2074550) is affixed to the
screen edge as shown. The modified master clamper (P/N C2074948) must be installed.
The drum lock function cannot be used.
9. The drum lock and the drum master detection functions cannot be used; however, the
first few prints made when the Master Making key is pressed will be better than those
made on a standard drum.
10. The modified master clamper (P/N C2074948) must be installed.
11. The drum lock and the drum master detection functions cannot be used; however, this
drum produces better quality images than a standard drum.
12. The rear paper delivery side plate [C] (P/N C2136119) used on the VT series must be
installed.
[A]
4-23
[B]
28 February '91
[B]
[C]