Ricoh PRIPORT VT 2000 Series Service Manual page 260

7.9 SECOND FEED ROLLER SECTOR STOPPER
CLEARANCE ADJUSTMENT
0.1 -- 0.3 mm
Purpose: To ensure that the second feed roller starts rotating when the
paper feed solenoid turns on and stops rotating when the paper
feed solenoid turns off.
1. Remove the rear cover of the machine.
2. Gradually turn the drum rotating shaft [A] counterclockwise with a
spanner (10 mm).
3. After turning the sector gear [B] fully counterclockwise, make sure that
the clearance between the sector pin [C] and the sector stopper [D] is 0.1
to 0.3 mm.
4. If the clearance is incorrect, loosen the Allen screws [E] and adjust the
clearance between the sector pin and the sector stopper.
[C]
[D]
5-47
[B]
[E]
28 February '91
[A]