Ricoh PRIPORT VT 2000 Series Service Manual page 277

28 February '91
9.5 MASTER FEED CLAMPER CAM ADJUSTMENT
Purpose: To ensure that the master feed clamper is opened during the
master feed process and is closed during other processes.
1. Remove the drum unit from the machine and open the master eject unit.
2. Remove the rear cover of the machine
3. Access I/O check mode (See page 4-11).
Enter "0" in the memory display and "9" in the copy counter.
•
4. Press the Print Start key to turn on the master feed clamper solenoid [A].
5. Make sure that the distance between the busing and the edge of the
opening cam [B] is 29±0.5 mm when the master feed clamper solenoid
turns on.
6. If not, loosen the mounting screws [C] and adjust the solenoid position.
CAUTION: Do not turn on the solenoid any longer than 10 seconds.
7. After adjustment, retighten the mounting screws.
[C]
ON= 29±0.5 mm
[B]
OFF= less than 25 mm
5-64
[A]
[B]