Ricoh PRIPORT VT 2000 Series Service Manual page 187

28 February '91
7. Idling
a. While holding down the "0" key,
press the Reset key on the opera-
tion panel.
b. If (
blinks, press the Reset key.
8. Test Printing
a. Adjust the original guide to match
the original size.
b. Set the original face down.
c. Input the desired number of prints
with the number keys and press the
Master Making key.
NOTE for VT2100/VT2130/2150:
With a new drum, the master
paper misfeed indicator
+ F blinks because there is no
master yet on the drum. Press
the Reset key, then press the
Master Making key.
d. After one sheet of paper is deliv-
ered, press the Print Start key to
make prints at the lowest print
speed (1) until the print image den-
sity stabilizes. Use a test chart to
check the image density.
e. Check the copy image after about
one hundred prints.
+ D: VT2100/2130/2150)
3-20