Ricoh PRIPORT VT 2000 Series Service Manual page 102

T4: The reverse roller solenoid and the master feed clamper solenoid are
de-energized when the master is fed 61 mm.
After the reverse roller solenoid is de-energized, the master buckles
and the master buckle sensor is activated. At the same time the main
motor turns on to wrap the master around the drum. When the master
is fed to the drum, the master buckle sensor is de-activated, and the
main motor stops. The master continues to feed by repeating the
above steps, controlled by the ON/OFF action of the buckle sensor.
T5: The main motor stops after the master paper is fed 438 mm for B4/LG
(371 mm for A4.) At the same time the cutter motor rotates to cut the
master paper.
T6: When the cutter returns to the home position, the master feed motor
rotates again to feed the master paper 42 mm.
2-75
28 February '91