Ricoh PRIPORT VT 2000 Series Service Manual page 13

No. Name
16. Master Cut Button
17. Pressure Release
Lever
18. Drum Rotating
Button
19. Drum Unit
20. Ink Holder
21. Main Switch
22. Small Size Paper
Delivery End Plate
(for smaller than
A4/LT)
23. Paper Delivery End
Plate (for larger
than A4/LT)
24. Paper Delivery
Side Plate
25. Master Eject
Container Cover
26. Memory/Class switch
(VT2300/2500)
27. Skip Paper Feed
Switch (VT2300/2500)
Printing Density
Select Switch
(VT2100/2130/2150)
28. Master Eject Unit
Open Button
Function
Press this button to cut the master paper leading
edge after installing a new master roll.
Use to install the master roll, or to clean the
thermal head.
Press to replace the drum or to remove misfed
paper.
The master paper is wrapped around this unit.
Set the ink cartridge in this holder.
Use to turn the power on or off.
Use to align the leading edge of small-sized (less
than A4/LT) prints.
Use to align the leading edge of prints larger than
A4/LT.
Use to align the prints on the paper delivery table.
Open when removing the master eject container.
Use to select memory or class mode.
Use to adjust paper feed interval or a misted
master.
Use to select the printing density according to the
type and quality of the original.
Press to remove misfed paper or a misfed master.
1-11
28 February '91