Konica Minolta BIZHUB 25E Field Engineering Manual page 213

Detail
Phase Error code
Error code
Tx Phase B T.2.2 110E
1115
1116
T.2.3 1023
Tx Phase C T.3.1 1031
Tx Phase D T.4.1 1041
T.4.2 1042
T.5.1 1051
T.5.2 1052
T.5.3 1053
Tx V34 start T.8.1 1081
up
1800
1801
1802
1803
T.8.10 108A
T.8.11 108B
Transmission T.1.4 1014
canceled
Description
The receiver has no box with
matching sub-address
Cannot fast remote diagnose
Trouble report was sent, but the
receiver was not a diagnose host
FTT returned at 2400 bps
Document feeding error
Document length was over 1m
Lamp error
Scanner cover open error
Cannot receive MCF/RTN/RTP/
PIP/PIN
RTN was received
No response to RR
No response to CTC
EOR output
V8 process did not finished
normally
Primary channel instruction did not
match at V8 mode
Primary channel instruction did not
match at V8 mode (TX FAX)
Primary channel instruction did not
match at V8 mode (RX FAX)
Cannot adjust modulation
Cannot finish line probing normally No
Cannot finish equalizer training
normally
Operator canceled the transmission Yes
Journal Redial
Yes No F-Code Tx Error. No F-Code information in the
remote machine.
Yes No No High-speed RDS. Cannot send a data.
Cannot send a trouble report. Remote machine is
not RDS host.
Cannot receive with minimum speed.
Yes No Scanning error. Please send again.
Yes Only at Confirm the remote fax.
memory
Tx
No The remote machine could not receive document.
No Confirm the remote fax.
No
Cannot receive with minimum speed.
Yes No Cannot send a fax in SuperG3 mode.
Yes
No Fax job was cancelled by user.
4-7
Message
This error occurs at manual
reception.
Note