Guide Inner - Konica Minolta BIZHUB 25E Field Engineering Manual

GUIDE INNER

1. Remove the Cover Tx side B. (See "COVER TX SIDE B" on page 5-5.)
2. Remove the Cover Tx side F. (See "COVER TX SIDE F" on page 5-8.)
3. Remove the Cover Tx. (See "COVER TX" on page 5-17.)
4. Disconnect the connector for the Sensor TxIL [1] and the Sensor DS1 [2].
5. Leave the Clutch URADF (separate clutch) [3] (regist clutch) [4] junction connector towards the Clutch
URADF and disconnect the connector on the harness side.
6. Pull out the harness from the GUIDE INNER [5] hole [6].
7. Push down the handle of the Bracket APS [7] and remove it.
8. Remove two screws [8].
9. Lift up the GUIDE INNER [5] a little and release two hooks [9].
NOTE
When reassembling the unite, note that two hooks [9] are not on the platen cover but under the hooks of
the cover.
5-24