Guide Harness - Konica Minolta BIZHUB 25E Field Engineering Manual

Hide thumbs Also See for BIZHUB 25E:

Table of Contents

GUIDE HARNESS

1. Remove the Cover Tx side B. (See "COVER TX SIDE B" on page 5-5.)

2. Remove seven harness locks [1].

3. Remove one screw [2] and remove the secured Cover Tx ground wire.

4. Disconnect all the PCB ADF [3] connectors.

5. Remove the harness from the GUIDE HARNESS [4].

6. Remove the harness from three hooks [5].

7. Remove one screw [6].

8. Release the hook [7] and remove the GUIDE HARNESS [4] while pulling two insertions [8].

* Release the hook by slightly pressing down the GUIDE HARNESS [4].

Table of Contents