Pcb Ncu - Konica Minolta BIZHUB 25E Field Engineering Manual

Hide thumbs Also See for BIZHUB 25E:

Table of Contents

PCB NCU

1. Remove the Plate printer B. (See "PLATE PRINTER B" on page 5-22.)

2. Remove the Cover back. (See "PCB MAIN" on page 5-34.)

3. Remove one screw [1], and remove the Cover L B [2].

4. Remove one screw [3].

* The screw is jointed with the ground wire [4].

5. Disconnect one PCB NCU connector [5].

6. Remove four screws [6].

7. Remove the PCB NCU [8] while disconnecting the connector part [7] from the frame.

Table of Contents