Saving Your Configuration; Commands; Table 92 Commands - ZyXEL Communications IES-1248-71 User Manual

Chapter 44 Commands
Administrators with middle privilege access can use middle or low privilege commands.
Administrators with the low privilege level are restricted to using only low privilege
commands. Low privilege commands are read only.

44.3 Saving Your Configuration

Use the following command to save your configuration when you are done with a
configuration session.
ras> config save
Do not turn off your IES-1248 while saving your configuration.
This command saves all system configurations to nonvolatile memory. You must use this
command to save any configuration changes that you make, otherwise the IES-1248 returns to
its default settings when it is restarted. Save your changes after each configuration session.
Nonvolatile memory refers to the IES-1248's storage that remains even if the IES-1248's
power is turned off. Run-time (memory) is lost when the IES-1248's power is turned off.

44.4 Commands

The following table lists commands that you can use with the IES-1248.
The P column on the right indicates the administrator privilege level needed to use the
command (H for high, M for middle or L for low) and the equivalent in the web configurator
(H for high, M for middle or L for low).

Table 92 Commands

CLASS COMMAND
sys
info show
info hostname
info location
info contact
passwd
reboot
snmp show
snmp getcommunity
278
PARAMETERS DESCRIPTION
Displays general system
information.
Sets the system name.
<hostname>
Sets location information.
<location>
Sets contact person information.
<contact>
Sets the reboot timer or displays
[show|sec|cancel]
the timer and remaining time for
reboot. If a reboot has been
scheduled, use this command to
prevent a reboot.
Displays SNMP settings.
Sets the SNMP GetRequest
<community>
community.
P
L/L
M/L
M/L
M/L
H/H
M/L
H/H
IES-1248-71/73 User's Guide