Table 45 Mvlan Group - ZyXEL Communications IES-1248-71 User Manual

The following table describes the labels in this screen.

Table 45 MVLAN Group

LABEL
MVLAN Status
MVLAN Setup
MVLAN ID
Index
Start Multicast IP
End Multicast IP
Apply
Cancel
MVLAN ID
Name
State
Entry Index
Start Multicast IP
End Multicast IP
Select
Delete
Cancel
IES-1248-71/73 User's Guide
DESCRIPTION
Click MVLAN Status to open the MVLAN Status screen where you can view a
summary of all multicast VLAN on the IES-1248 (see
179).
Click MVLAN Setup to open the MVLAN Setup screen where you can
configure basic settings and port members for each multicast VLAN (see
Section 22.3 on page 180).
Select the VLAN ID of the multicast VLAN for which you want to configure a
range of multicast IP addresses.
Select the index number of the multicast VLAN group (the range of multicast IP
addresses) you want to configure for this multicast VLAN. If you want to change
the current settings, select an index number that already exists. If you want to
add a new multicast VLAN group, select an index number that does not exist.
Enter the beginning of the range of multicast IP addresses. The IP address must
be a valid multicast IP address, between 224.0.0.0 and 239.255.255.255.
Enter the end of the range of multicast IP addresses. The IP address must be a
valid multicast IP address, between 224.0.0.0 and 239.255.255.255.
Click Apply to save your changes to the IES-1248's volatile memory. The IES-
1248 loses these changes if it is turned off or loses power, so use the Config
Save link on the navigation panel to save your changes to the non-volatile
memory when you are done configuring.
Click Cancel to begin configuring the fields afresh.
Select the VLAN ID of the multicast VLAN for which you want to look at or
remove the multicast IP addresses currently added to it.
This field displays the name of this multicast VLAN.
This field shows whether this multicast VLAN is active (Enable) or inactive
(Disable).
This field displays the index number of each multicast VLAN group (the range of
multicast IP addresses) configured for this multicast VLAN.
This field displays the beginning of this range of multicast IP addresses.
This field displays the end of this range of multicast IP addresses.
Select this, and click Delete to remove the multicast VLAN group.
Click this to remove the selected multicast VLAN groups.
Click Cancel to begin configuring the fields afresh.
Chapter 22 Multicast VLAN
Section 22.2 on page
183