Isolation Commands; Isolation Show Command; Isolation Enable Command; Isolation Disable Command - ZyXEL Communications IES-1248-71 User Manual

An example is shown next.

Figure 145 Info Show Example

ras> sys info show
Hostname:
Location:
Contact:
ZyNOS version: V3.52(LS.0) | 05/11/2006
F/W size: 2675582
MAC address: 00:13:49:73:22:24
System up time:
Bootbase version: V1.09 | 01/18/2005
F/W build date: May 10 2006 11:40:04
DSP code version: f2.33.0000
Hardware version:
Serial number:

45.4 Isolation Commands

Turn on port isolation to block communications between subscriber ports. When you enable
port isolation, you do not need to configure the VLAN to isolate subscribers.

45.4.1 Isolation Show Command

Syntax:
ras> switch isolation show
This command displays the current setting of the subscriber isolation feature.
An example is shown next.

Figure 146 Isolation Show Example

ras> switch isolation show
system isolation: enabled

45.4.2 Isolation Enable Command

Syntax:
ras> switch isolation enable
This command turns on the subscriber isolation feature.

45.4.3 Isolation Disable Command

Syntax:
ras> switch isolation disable
This command turns off the subscriber isolation feature.
IES-1248-71/73 User's Guide
Model: IES1248-71
0(days) :
Chapter 45 Command Examples
3:10:26
301