Vlan Cpu Show Command; Vlan Cpu Set Command; Configuring Management Vlan Example; Figure 165 Vlan Frame Type Command Example - ZyXEL Communications IES-1248-71 User Manual

The IES-1248 accepts both tagged and untagged incoming frames on the
Ethernet ports.
The following example sets the IES-1248 to accept only VLAN tagged Ethernet frames on
DSL port 3.

Figure 165 VLAN Frame Type Command Example

ras> switch vlan frametype 3 tag

48.4.6 VLAN CPU Show Command

Syntax:
ras> switch vlan cpu show
This command displays the management VLAN (CPU). You can only use ports that are
members of this management VLAN in order to manage the IES-1248.
The following example sets VLAN ID 2 to be the CPU (management) VLAN.

Figure 166 VLAN CPU Set Command Example

ras> switch vlan cpu set 2

48.4.7 VLAN CPU Set Command

Syntax:
ras> switch vlan cpu set <vid>
where
<vid>
This command sets the management VLAN (CPU). You can only use ports that are members
of this management VLAN in order to manage the IES-1248.
The following example sets VLAN ID 2 to be the CPU (management) VLAN.

Figure 167 VLAN CPU Set Command Example

ras> switch vlan cpu set 2

48.4.8 Configuring Management VLAN Example

After the following example configuration, you must connect to the first
Ethernet port through a VLAN aware device that is using the proper VLAN ID
in order to perform management.
IES-1248-71/73 User's Guide
Chapter 48 IEEE 802.1Q Tagged VLAN Commands
The VLAN ID. Valid parameter range = [1 – 4094].
=
325