Figure 274 2684 Routed Mode Example; Figure 275 2684 Routed Mode Commands Example - ZyXEL Communications IES-1248-71 User Manual

Chapter 56 Virtual Channel Management

Figure 274 2684 Routed Mode Example

Note the following.
• The CPE device's WAN IP (192.168.10.200 in this example) must be in the same subnet
as the gateway's IP address (192.168.10.102 in this example).
• The IES-1248's management IP address can be any IP address, it doesn't have any
relationship to the WAN IP address or routed gateway IP address.
• The IES-1248's management IP address should not be in the same subnet as the one
defined by the WAN IP address and netmask of the subscriber's device. It is suggested that
you set the netmask of the subscriber's WAN IP address to 32 to avoid this problem.
• The IES-1248's management IP address should not be in the same subnet range of any
RPVC and RPVC domain. It will make the IES-1248 confused if the IES-1248 receives a
packet with this IP as destination IP.
• The IES-1248's management IP address also should not be in the same subnet as the one
defined by the LAN IP address and netmask of the subscriber's device. Make sure you
assign the IP addresses properly.
• In general deployment, the computer must set the CPE device's LAN IP address
(10.10.10.10 in this example) as its default gateway.
• The subnet range of any RPVC and RPVC domain must be unique.
Use the following command sequence to configure the IES-1248 for this example set up.

Figure 275 2684 Routed Mode Commands Example

ras> adsl rpvc gateway set 192.168.10.102 1
ras> adsl rpvc set 1 8 35 DEFVAL 192.168.10.200/32 192.168.10.102
ras> adsl rpvc route set 1 8 35 10.10.10.1/24
404
IES-1248-71/73 User's Guide