Alarm Profile Set Command - ZyXEL Communications IES-1248-71 User Manual

55.3.2 Alarm Profile Set Command

Syntax:
ras> adsl alarmprofile set <profile> [<atuc lofs> <atur lofs> <atuc loss>
<atur loss> <atuc lols> <atuc lprs> <atur lprs> <atuc ess> <atur ess> <atuc
fast rateup> <atur fast rateup> <atuc interleave rateup> <atur interleave
rateup> <atuc fast ratedown> <atur fast ratedown> <atuc interleave ratedown>
<atur interleave ratedown> <init fail enable> <atuc fail fast> <atuc ses>
<atur ses> <atuc uas> <atur uas>]
where
<profile>
atuc
atur
<atuc lofs>
<atur lofs>
<atuc loss>
<atur loss>
<atuc lols>
<atuc lprs>
<atur lprs>
<atuc ess>
<atur ess>
<atuc fast
rateup> <atur
fast rateup>
<atuc
interleave
rateup> <atur
interleave
rateup>
<atuc fast
ratedown> <atur
fast ratedown>
<atuc
interleave
ratedown> <atur
interleave
ratedown>
<init fail
enable>
<atuc fail
fast>
IES-1248-71/73 User's Guide
A name for the alarm profile (up to 31 ASCII characters).
=
Upstream. These parameters are for the connection (or traffic)
=
coming from the subscriber's device to the IES-1248.
Downstream. These parameters are for the connection (or
=
traffic) going from the IES-1248 to the subscriber's device.
The number of Loss Of Frame that are permitted to occur within
=
15 minutes.
The number of Loss Of Signal that are permitted to occur within
=
15 minutes.
The number of Loss Of Link that are permitted to occur within
=
15 minutes.
The number of times a Loss of Power is permitted to occur (on
=
the ATUR) within 15 minutes.
The number of Errored Seconds that are permitted to occur
=
within 15 minutes.
A rate in kilobits per second (kbps). If a fast mode connection's
=
upstream transmission rate increases by more than this number,
then a trap is sent.
A rate in kilobits per second (kbps). If an interleave mode
=
connection's upstream transmission rate increases by more than
this number, then a trap is sent.
A rate in kilobits per second (kbps). If a fast mode connection's
=
downstream transmission rate decreases by more than this
number, then a trap is sent.
A rate in kilobits per second (kbps). If an interleave mode
=
connection's upstream transmission rate decreases by more than
this number, then a trap is sent.
"1" sets the profile to trigger an alarm for an initialization
=
failures trap. "2" sets the profile to not trigger an alarm for an
initialization failures trap.
The number of failed fast retrains that are permitted to occur
=
within 15 minutes.
Chapter 55 ADSL Commands
391