Table of Contents
Advertisement
C
H A P T E R
This chapter describes initial configuration for the IES-1248. See
various default settings of the IES-1248.
8.1 Initial Configuration Overview
This chapter shows what you first need to do to provide service to ADSL subscribers.
8.2 Initial Configuration
This chapter uses the web configurator for initial configuration. See Part
the commands. Use Internet Explorer 6 and later versions with JavaScript enabled.
1 Log in to the web configurator. See
2 In the navigation panel, click Basic Setting, IP Setup. The IP Setup screen appears.
Figure 31 IP Setup
3 Use this screen to change the IP address, subnet mask, and default gateway IP address
for your network. Apply the settings.
If you change the IP address of the IES-1248, after you click Apply IP setting,
you have to use the new IP address to log into the web configurator again.
IES-1248-71/73 User's Guide
Initial Configuration
Section 7.3 on page 75
8
Appendix A on page 439
for
V
for information on
for instructions.
83
Advertisement
Table of Contents
Troubleshooting
