Chapter 48 IEEE 802.1Q Tagged VLAN Commands
By default, the IES-1248's ADSL ports are members of the management VLAN (VID 1). The
following procedure shows you how to configure a tagged VLAN that limits management
access to just one Ethernet port.
Use the console port to configure the IES-1248 if you misconfigure the
management VLAN and lock yourself out.
1 Use the switch vlan set command to configure a VLAN ID (VID 3 in this
example) for managing the IES-1248 (the "management" or "CPU" VLAN).
Figure 168 CPU VLAN Configuration and Activation Example
ras> switch vlan set 3 enet1:FT
2 Use the switch vlan1q vlan cpu command to set VID 3 as the management
VLAN.
Figure 169 Deleting Default VLAN Example
ras> switch vlan cpu set 3
48.4.9 VLAN Delete Command
Syntax:
ras> switch vlan delete <vlanlist>
where
<vlanlist>
This command deletes the specified VLAN ID entry from the static VLAN table. The
following example deletes entry 2 in the static VLAN table.
Figure 170 VLAN Delete Command Example
ras> switch vlan delete 2
48.5 VLAN Enable
Syntax:
ras> switch vlan enable <vid>
This command enables the specified VLAN ID in the SVLAN (Static VLAN) table.
326
You can specify a single VID: <1>, all VIDs: <*>, a list of
=
VIDs: <1,3>, you can also include a range of VIDs: <1,5,6~10>.
IES-1248-71/73 User's Guide