2684 Routed Pvc Screen; Figure 107 2684 Routed Mode Example - ZyXEL Communications IES-1248-71 User Manual

Chapter 30 2684 Routed Mode

Figure 107 2684 Routed Mode Example

Note the following.
• The CPE device's WAN IP (192.168.10.200 in this example) must be in the same subnet
as the gateway's IP address (192.168.10.102 in this example).
• The IES-1248's management IP address can be any IP address, it doesn't have any
relationship to the WAN IP address or routed gateway IP address.
• The IES-1248's management IP address should not be in the same subnet as the one
defined by the WAN IP address and netmask of the subscriber's device. It is suggested
that you set the netmask of the subscriber's WAN IP address to 32 to avoid this problem.
• The IES-1248's management IP address should not be in the same subnet range of any
RPVC and RPVC domain. It will make the IES-1248 confused if the IES-1248 receives a
packet with this IP as destination IP.
• The IES-1248's management IP address also should not be in the same subnet as the one
defined by the LAN IP address and netmask of the subscriber's device. Make sure you
assign the IP addresses properly.
• In general deployment, the computer must set the CPE device's LAN IP address
(10.10.10.10 in this example) as its default gateway.
• The subnet range of any RPVC and RPVC domain must be unique.

30.2 2684 Routed PVC Screen

Use this screen to configure PVCs for 2684 routed mode traffic.
To open this screen, click Advanced Application, 2684 Routed Mode.
210
IES-1248-71/73 User's Guide