Setting Up Port Forwarding Function - EverFocus 288 Series User Manual

C. Setting up Port Forwarding Function
IP Camera port forwarding can be used when users need to access a certain IP camera from outside of the
local network where the IP camera is connected to.
To enable the IP camera port forwarding function, you have to configure the port forwarding settings both
on the IP camera and the router (UPnP-enabled). Please follow the steps below:
Internet
1. Go to System > System Settings > Network > IP Settings.
a. Set up a static IP for the IP camera. Type in the subnet mask, gateway and the DNS if provided
by the Internet Service Provider.
b. Enter the port numbers and check the Enable UPnP box to enable the port forwarding function.
Click the Save button.
The default ports of all EverFocus' IP cameras are as below. You can change the port numbers if
necessary. Be sure the port numbers setup on the router match the ones setup here.
HTTP: 80
PC
Local Network
Router Switch
80
Value IP 288 / 368 / 468 Series
IP Camera
Notebook