Table of Contents
Advertisement
D. Setting up Port Forwarding Function
IP Camera port forwarding can be used when users need to access a certain IP camera from outside of the
local network where the IP camera is connected to.
To enable the IP camera port forwarding function, you have to configure the port forwarding settings both
on the IP camera and the router (UPnP-enabled). Please follow the steps below:
Internet
1. Go to System > System Settings > Network > IP Settings.
a. Set up a static IP for the IP camera. Type in the subnet mask, gateway and the DNS if provided
by the Internet Service Provider.
b. Enter the port numbers and check the Enable UPnP box to enable the port forwarding function.
Click the Save button.
The default ports of all EverFocus' IP cameras are as below. You can change the port numbers if
necessary. Be sure the port numbers setup on the router match the ones setup here.
HTTP: 80
PC
Value IP 2MP 288 Series / 3MP 368 Series
Local Network
Router
Switch
76
IP Camera
Notebook
Advertisement
Table of Contents
