6.2
Setting Up the Playback Function
Note that the Playback function will not be active until the user has inserted an SD card in the
camera's SD card slot. The card may also have to be formatted in the Settings submenu.
6.2.1 Preparing the SD Card
Once you insert a functional SD card into the slot, the Playback button on the Live page should
become active within seconds (see section 6.2.2 below – the grey letters should turn white). IF NOT,
do the following:
1. From the Live page, click Settings > System > SD Card. If no card has been inserted yet, the
Remove button should be faded, indicating that no card is being detected. (If a card is inserted,
and the Remove button is still faded, pull the card out and re‐insert it.)
2. Slide the card into the slot until it clicks into position.
3. The Remove button should become active within a few seconds, indicating the card is active.
4. If the Remove button stays faded, click the Format button to format the card. NOTE: All data on
the disk will be deleted if the Format button is clicked.
6.2.2 Testing the Playback Function
1. Once the SD card is detected by the system, the button
to
2. To optionally test the Playback function, set up a "Manual Trigger" Recording Event by clicking
Settings > Event > Event Settings.
(active).
22
(inactive) will turn
EHN Plus Series