EverFocus 288 Series User Manual page 23

EMN468/468W
1. Before screwing the camera onto the surface, stick the Sticker onto the surface to mark the position
for installation. According to the supplied Sticker, drill three holes on the surface, and optionally
drill a through-out hole for wiring the camera cables. Push the supplied three Screw Anchors into
the three holes on the surface.
2. Unscrew the camera cover and screw the camera base to the surface by using the supplied Screws.
Note that for EMN468W, place the supplied Gasket between the camera base and the surface; and
then screw the camera base to the surface with the Gasket in the middle.
3. Connect the LAN / PoE cable to the camera.
a. Remove the Screw Cap from the Cable Gland.
b. Insert a RJ-45 network cable (without the RJ-45 connector on the one end) through the Cable
Gland and Screw Cap.
c. Place the Waterproof Ring into the LAN / PoE cable. Connect the RJ-45 cable to the RJ-45
Connector Cable. Tightly screw the Cable Gland and Screw Cap to the RJ-45 Connector Cable.
17
Value IP 288 / 368 / 468 Series