Table of Contents
Advertisement
3.
Loosen the four screws on the IPC board.
4.
Insert a micro SD card into the card slot.
5.
Put the water-proof ring on the groove that near the edge of the housing. Place the desiccant
bag beside the IPC board.
6.
Screw back the IPC board, secure the rear housing back to the front housing and tighten the set
screws on the bracket.
Note: Please make sure you wear the antistatic gloves or antistatic wrist strap when installing the
Micro SD card to protect the device from damage.
Desiccant bag
Water-proof ring
24
Value IP 288 / 368 / 468 Series
Advertisement
Table of Contents
