4.4. Basic Installation
4.4.1.
Mounting and Wiring
EBN288/368/468
1. Before screwing the camera to the wall, stick the Sticker on the wall / ceiling to mark the position
for installation. Drill four holes on the wall / ceiling according to the supplied Sticker and push the
supplied four Screw Anchors into the four holes on the wall / ceiling. Drill another hole in the
middle of the Sticker if you wish to run the wires into the wall / ceiling.
2. Twist the Outer Housing counterclockwise and then remove the Outer Housing from the camera
base.
3. Place the camera base on the wall / ceiling and run the cable through the camera base first.
4. Tread the cables:
a. From the side cut of the camera base
11
Value IP 288 / 368 / 468 Series