Appendix; A.setting-Up And Operating Eptz Camera Function Using Ekb500 - EverFocus EPTZ3602 User Manual

Appendix

A. Setting-up and Operating EPTZ Camera Function Using EKB500
Manual Control Mode
•
Manual control: Shift Joystick Up/Down/Left/Right, and turn it Clockwise/Counterclockwise to
control speed dome.
Use the control keys which are Zoom, Focus and IRIS function keys on the keyboard to Zoom In/Out,
focus N (near)/F (Far), or IRIS +/-.
Note: Zoom In/Out control keys will be disabled when entering to OSD menu mode.
•
HOME Mode: The camera view will go back to the home position when there is no keyboard
operation in a specific time. The home position and the specific time can be set by pressing Set +
Home.
If you set the time to 0 minute, then the camera will go back to home if there is no keyboard
operation in 5 seconds. This is the minimum no action time for HOME mode.
Note: If "HOME" function is enabled, dome will go to home immediately after powering on.
Auto Pan Mode
•
Two point auto pan: Press A.Pan to enter the auto pan mode, and then the system will ask you to
enter the auto pan speed (1~239). Press Enter to start auto pan.
In order to set the two points, press Set + A.Pan, and then enter the dwell time (1~127 seconds) of
each point. The EPTZ camera begins to pan from point A to point B clockwise.
•
360° auto pan: Press Shift + A.Pan to enter the 360° auto pan. System will ask you to enter 360°
auto pan speed (1~239). The camera will turn 360° automatically, but not tilt.
Position Setting
•
Focus on a preset position: Press the number key, and then press Position to focus on the number
of preset position; or you can press Position, then enter the preset position number, and then press
Enter to focus on the number of preset position.
•
Preset a position: Shift the Joystick to the position you would like to preset, and then press Shift +
Position. The system will ask you to enter the preset position number (1~192), and then press Enter
to save the position. There are up to 192 positions can be preset.
Three specific preset positions can be set as follows:
92 => Set Left Limit Stop (A position)
93 => Set Right Limit Stop (B position)
95 => Enter Menu mode (Use keyboard control keys to control OSD items; Focus F. to go
downward, Focus N. to go upward. IRIS + go to previous setting and IRIS – to exit).
44
EPTZ3602/3602i