Table of Contents
Advertisement
Night to Day: You can configure the sensitivity for Auto(AGC) Day/Night Mode ranging from 0-255.
The camera will automatically switch from night mode to day mode based on the setup sensitivity.
The default value is 35.
Light Board Control
Mode: Select a mode (OFF, Manual, Auto) from the drop-down list. The default Light Board Control
mode is OFF.
Brightness: You can configure the brightness for Manual Light Board Control Mode.
Advanced Settings
TWDR (True Wide Dynamic Range): The WDR function provides clearer images when both of the
very bright and dark areas simultaneously appear on the camera view. There are four value options:
OFF, Low, Mid and High. Note that when WDR is enabled, some parts of the image may appear
solarized. This is normal for WDR, and is not a camera malfunction. The default TWDR mode is OFF.
3DNR (3D Noise Reduction): Noise Reduction limits the amount of digital "video noise" that is
usually found in any video stream, and helps to reduce file size. There are five value options: OFF,
Low, Mid, Mid-High and High. The default 3DNR mode is Low.
Defogging: The Defog function makes the subject appear clearer when the surrounding area of the
subject is foggy and low contrast. There are four value options: OFF, Low, Mid and High. The default
defogging mode is OFF.
Slow Shutter: Select from OFF or ON.
Note: Modifying the TWDR mode will cause the system to reboot automatically. Please create a new
network connection to the IP camera when the reboot is complete.
Exposure Control
Mode: Select a mode from Auto or Manual. The default Exposure mode is Auto.
Auto(AGC): Selecting Auto for the camera to automatically adjust the Shutter based on the
•
measured light level. You can further configure the AGC value.
Manual: Select this option to manually set up the Shutter value.
•
AGC: For Auto(AGC) Exposure mode, you can further configure the AGC value. Select the Auto Gain
Control level from Low to High. The lower the AGC level, the lower the video signal and the noise.
The higher the AGC level, the better the sensitivity under low illumination, while the noise will be
more obvious. The default AGC level is Mid-High.
57
Value IP 288 / 368 / 468 Series
Advertisement
Table of Contents
