Avaya S8800 Manual page 28

Replace the Avaya S8800 Server and its components
Important:
Always use an electrostatic-discharge wrist strap or other grounding system when you work
inside the server. For more information, see
Procedure
1. Turn off the server and all attached devices.
2. Label and disconnect all power cords and external cables.
3. Remove the cover.
4. If a card is installed in the PCI riser-card assembly, disconnect any cables that are
5. Grasp the blue tab near the rear of the PCI riser-card assembly from the rear and
28 Maintaining the Avaya S8800 Server for Avaya Aura
connected to the card.
lift it out of the PCI riser-card slot on the system board. See the following figure.
1
2
3
4
Comments? infodev@avaya.com
Protecting against ESD damage
PCI riser connector 2
PCI riser-card assembly (full-height,
half-length PCIe cards)
PCI riser-card assembly (low profile
PCIe cards)
PCI riser connector 1
®
Communication Manager
on page 10.
July 2012