Avaya S8800 Manual page 32

Replace the Avaya S8800 Server and its components
the system board before you turn on the server. An incorrectly seated PCIe card might cause
damage to the system board, the riser-card assembly, or the PCIe card.
Important:
Always use an electrostatic-discharge wrist strap or other grounding system when you work
inside the server. For more information, see
Procedure
1. Connect any required cables to the PCIe card. Follow the cabling instructions that
2. Insert the PCIe card into the riser-card assembly, aligning the edge connector on
3. Install the riser-card assembly in the server.
4. Perform any configuration tasks that are required for the PCIe card.
32 Maintaining the Avaya S8800 Server for Avaya Aura
came with the PCIe card. Route the card cables before you install the card.
the card with the connector on the riser-card assembly. Press the edge of the
connector firmly into the riser-card assembly. Make sure that the PCIe card snaps
into the riser-card assembly securely. See the following figure.
1
2
Comments? infodev@avaya.com
Protecting against ESD damage
PCIe card
PCI riser-card assembly
®
Communication Manager
on page 10.
July 2012