Avaya S8800 Manual page 19

2. If you are planning to install or remove a DIMM, PCI card, battery, or other non-hot
3. If the server has been installed in a rack, slide the server out from the rack
4. Press down firmly on the blue tab on the top (near the front of the server) of the
5. Lift the server cover off the server and set it aside.
Installing the server cover
About this task
Important:
Always use an electrostatic-discharge wrist strap or other grounding system when you work
inside the server. For more information, see
Maintaining the Avaya S8800 Server for Avaya Aura
swap device:
a. Turn off the server and all attached devices.
b. Label and disconnect all power cords and external cables.
enclosure.
cover and slide the cover toward the back of the server until the cover has
disengaged from the chassis. See the following figure.
1
2
Important:
For proper cooling and airflow, replace the cover before you turn on the server.
Operating the server for extended periods of time (over 30 minutes) with the cover
removed might damage server components.
Cover
Tab
Protecting against ESD damage
®
Communication Manager
Replace the hardware components
on page 10.
July 2012 19