Alcatel-Lucent 1665 Installation Manual page 273

WDMX setup and testing: integration procedures
........................................................................................................................................................................
................................................................................................................................................
6
Click Select, then select REMAID and the port will appear on the right side of the screen,
click on the Port to highlight it then click Select.
................................................................................................................................................
7
Click Select for the Add/Drop port, expand the circuit pack (OMD5/8) and click on the
Port and the port will appear on the right side of the screen, click on the Port to highlight
it then click Select.
Note:
................................................................................................................................................
8
Click Next, then Finish and complete the cross-connection by clicking on Yes in the
confirmation window.
................................................................................................................................................
9
Connect fibers from Test port to selected channel on LNW785, while observing optical
power requirements and cleaning procedures.
................................................................................................................................................
10
Repeat
................................................................................................................................................
11
Connect the Transmit fibers on the LNW785 at each end, following proper fiber cleaning
procedures.
................................................................................................................................................
12
Connect the Receive fibers on the LNW785 at each end, while observing optical power
requirements and cleaning procedures.
Result:
................................................................................................................................................
13
If adding a span in the other direction using the LNW785 repeat
otherwise continue.
................................................................................................................................................
14
Perform end-to-end testing. Follow the end to end testing procedures determined by the
input test signal. If the test signal is the Alcatel-Lucent 1665 DMXtend as part of a ring,
proceed to
appropriate procedure
........................................................................................................................................................................
Alcatel-Lucent 1665 DMXtend R10.0
365-372-327R10.0 Issue 1
January 2013
The port is determined by the test signal wavelength documented in
Step 2 to Step 9 at the remote Network Element.
Span is in-service
Chapter 8, "WDMX setup and testing: integration procedures"
Step .
Step 2 through Step 12,
and locate the
8 - 5