........................................................................................................................................................................

Function units/growth slots switching test

This test will initiate switching commands from the CIT and verify proper switching and

LED indications.

Note:

protected electrical TDM circuit packs.

................................................................................................................................................

Select

................................................................................................................................................

Click on

................................................................................................................................................

Select

Click

................................................................................................................................................

Note which function unit or growth slot circuit pack is the active circuit pack.

................................................................................................................................................

Switch Type:

In the

........................................................................................................................................................................

7 - 1 4

This procedure should be performed on each function unit equipped with

Fault > Protection Switch...

1+1 Equip fn-x

(x is a, b, d or g corresponding to the function group equipped).

pull-down, select

Manual (Normal)

Alcatel-Lucent 1665 DMXtend R10.0

365-372-327R10.0 Issue 1

January 2013

Table of Contents